If you are hanging a slab door to replace an existing door and you still have the original door you can measure your new door slab to fit the frame by aligning it with the old door.
Hanging a door with t hinges.
Make sure that a door stop is installed around the perimeter of the door opening.
How to fit a t hinge.
All using from the anvil.
Set it in the rough opening then level shim and nail it.
The hinge aspect a metal rod connecting the two halves of the hinge should be flush with the exterior edge of the frame.
Fix the t hinges strap hinges to the door face.
Don t fill the hinge up with all the screws yet in case it needs adjusting unless you are hanging a heavy fire check door.
A step by step guide on how to fit a set of t hinges to a plank door and then how to hang the door into a frame using the t hinges.
Go slowly and test fit your hinge a few times until you get it mounted flush.
Mark out and fix the t hinge once you are sure you have the right position for the t hinge mark out the screw holes on the door and mark out the position of the t hinge plate on the door frame.
Place door shims at the top and bottom hinge locations using a long level or a straight board and a short level.
Use wedges to firmly hold it in place and also remember to ensure any light switches are on the latch side of the door not the t hinge otherwise the switches will be hidden by the open door.
To do this place both doors next to each other on the thin long sides with the hinges on the old door facing up.
Lift the internal door out of the clamp offer it up to the frame at a slight angle and screw the top hinge to the lining first.
Screw the other halves of the hinges to the doorjamb.
Hang the door slotting the hinges together and slipping in the pins.
Screw the hinge leaf to the door.
Repeat the process for the other hinge along with the lock set.
Screw the shed door hinges to the door frame.
If you accidentally go too far you can place a thin wooden shim under your hinge to bring it back flush with the edge of the door.
Then add the center door shims.
Attach the hinges to the door frame using one screw per hinge initially.
Sometimes t hinges can be fitted to the outside part of the frame so a section of the architrave will need to.
You already know the standard approach to hanging a door.
Repeat on the other two hinges.
Drive the mounting screws through one screw hole in the hinge into the frame with a drill and screwdriver drill bit.
Attach the backplates or escutcheons and door knobs.
Align the doors so that the tops are even then use a clamp to hold the doors together.
You want to make a nice flat surface for your hinge to lay into.
