Hang Wreath On Stucco Wall Over Plywood

It specifies 7 8 inch exterior cement plaster over wood structural panel wall sheathing with 2x wood studs spaced 16 inches on center.

Hang wreath on stucco wall over plywood.

Mix your final coat using 1 part cement and 1 to 3 parts sand. Drill through the center of each traced hole with the masonry bit. Using clear rope twine or string make a loop on one end. Then gently remove the pressure against the object.

Push a cement wall anchor into each hole. Apply the stucco to create a 1 8 inch thick top coat. Use a plastic anchor something that will spread out when. This bit will drill through the stucco about 7 8 inch thick easily but may slow when it hits the sheathing or a wall stud behind the sheathing.

Fasten this loop around the upside down hook on your door and pull the string up and over the door onto the exterior side. The coating on the hardware will not rust and leave a rust mark on the stucco. Tap it flush with the wall using a rubber mallet if it doesn t go in easily. Drill about 1 8 inch deeper than the installation depth of the anchor.

Tie the other end of the string around one section of your wreath and let it hang. First of all use galvanized hardware nails screws etc. Add water until your stucco hangs off the trowel. A lot of questions that come to mind include things like can i screw into stucco and if so what kind of screws should i use and other related questions.

I show what tools needed and h. Stucco is a surprisingly hard surface and fastening anything to it can be a huge hassle if you are not properly prepared. If necessary switch to a wood bit to complete the hole. The contractor says he will remove the battens and put a waterproof membrane over the plywood siding then apply three coats of stucco on top of the wire.

Drive the masonry screws into the anchors with a power screwdriver. Wire lath is affixed to the substrate with.